Insert the power plug into the power outlet. Stops after 1 0sec. Scan lamp 1 Remove the table glass. Make a copy again, and check again that the value is in the specified range. Network communication error 4. Rear cabinet, rear lower cabinet 1 Remove the scanner rear cabinet and the rear lower cabinet. During execution of the automatic developer adjustment, the data LED blinks and the LCD indicates the toner sensor value.

Uploader: Tygojas
Date Added: 26 November 2018
File Size: 23.24 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 82198
Price: Free* [*Free Regsitration Required]

Process the harness cover as shown in the illustration.

The actual printable area depends sharp ar 450 the printer driver to be used. This means that this machine does not produce hazardous laser radiation. Adjustment Scanner reading Picture quality 5 Used to adjust the scan motor speed.

Parts included in the scanner unit Tray 1 pc. Check harness and connector in the communication line.

L8 01 Content No fullwave signal Detail Sharp ar 450 wave signal is not detected. Original detection light emitting unit height adjustment 1 Execute SIM Cause Abnormal installation of flat cable to CCD unit.

Replace the high voltage unit.

Page or product not found!

Operation test, check Finisher Operation 6 Used to sharp ar 450 the stacking capacity of the finisher. Paper jam X Note Possibly causing memory full. Remove the five screws that fix the printer control PWB unit to the main unit of the printer.

To prevent damage to the pins inside the connector, when inserting the connector, align the guides of the connector exactly.

Sharp AR-M Drivers Download – Update Sharp Software

Replace A Adjust Maintenance cycle: If the copy density is sharp ar 450 dark, decrease the adjustment value. Remove all pieces of packing tape and the screw that secure the scanner module and remove the packing, the notice sheet. By continuing to browse, you are agreeing to our use of cookies as explained in our Privacy Policy. Production sgarp identification A.

Sensors 1 Remove the upper transport unit cover. Trouble codes list 2. The same trouble as the previous one is sharp ar 450 recorded. Self print of set values Use of SIM allows to print the set values and the jam history of the machine. Data clear Counter 4 Used to reset the maintenance counter.

Sharp ar 450 the adjustment screw on the sharp ar 450 side rear of the a operation panel clockwise and counterclockwise to adjust the height of the LSU front side. AE mode 3 Set with 10 digit key pad. Adjustment, setup, operation data output, check display Trouble 5 Used to check the ROM version of each unit section.

If there is no data to be printed, the display returns to the initial state. Inhibited Fax 29 Used to clear the telephone directory.

Sharp AR-MN Network digital copier | armn

Sharp ar 450 adjustment shaep performed in the following cases: Then, remove the lock of the paper tray and close the tray. Print a self-print pattern All the PJL commands are not necessarily included in the compatibility. Binary value mode Quality mode Linked simulation data AE3. Engine section 3.

Cut the cut-off portions on both ends of the rear cabinet of sharp ar 450 desk unit by hand and remove them.